ATS Mini receiver ESP32 & SI4732 - matched stand

Here is the matched stand for ATS Mini ESP32 & SI4732 chipset receiver.

It is designed (all rights reserved to Skrycchio on Thingiverse) for easy connection of headphones, external antenna and easy access to the power switch.

The stand is also equipped with an acoustic cavity for conducting sound from the rear speaker to the front side of receiver.

As with all prints over here I will print it for free.
You will pay just shipping charges to your destination.

Standard color is Galaxy Black > better say dark grey color with glitters.
Also, I will add more and more colors in the future > just watch this page.

1pc. Free of charge. S/H $9.90 worldwide (Paypal fee included)








Comments

Post a Comment

Popular posts from this blog

BNC connectors - dust caps set

Image
Here is the set (6pcs) of dust caps designed for BNC coaxial connectors. It is the best solution for all hams using BNC connectors on their equipment in dusty environment. All caps has antistatic foam inside to make proper tensioning when cap is inserted and it makes also smooth protection for the BNC connector edge. Bayonet lock system in the cap provided. As it is with all prints over here I will print it for free. You will pay just shipping charges to your destination. Also I will add more and more colors in the future > just watch this page. 6pcs. Free of charge. S/H $8.90 worldwide (Paypal fee included)                                                                                   Navy blue
Read more

Vibroplex bugs - finger pieces replacement

Image
This kind of 3D printings are finger pieces replacement for Vibroplex bugs. It consists of both paddle and knob finger pieces in various colors. Few of my friends asked me to print it for them in order to replace damage pieces so here is offer for other bugs enthusiasts too. Just choose your preferred colors in any of combination you see below and drop me an email. When it will arrive you can just remove screws and replace old one or install new instead of damaged pieces. No threads printed so you can match to your actual screws used on the bug. It will cut out thread when you will screw-on it for the first time as I tested. As it is with all prints over there I will print it for free. You will pay just shipping charges to your destination. Also I will add more and more colors in the future > just watch this page. Free of charge. S/H $8.90 worldwide (Paypal fee included)                         ...
Read more

FA-VA5 analyzer - protecting covers

Image
The FA-VA5 antenna analyzer's housing is aluminium case. It is easy to make scratches and dents on the covers. This kind of 3D printing is set of the protecting covers. I was asked to print it for one of the analyzer in radio-club and here is offer for other owners too. As it is with all prints over here I will print it for free. You will pay just shipping charges to your destination. Also I will add more and more colors in the future > just watch this page. Free of charge. S/H $14.90 worldwide (Paypal fee included) Navy blue   
Read more